Blackstar ID:Core Stereo 10 Bedienungsanleitung PDF herunterladen (Seite 5)

English

Factory Reset

The default factory patches and settings can be restored to your amplier at any

time. Simply hold down the MOD, DLY and REV switches simultaneously, whilst

switching on the amplier.

The voice LED will count down to indicate that a factory reset is imminent. If any of

the MOD, DLY and REV switches are released before the Voice LEDs have switched

o, then the operation is cancelled and the amplier will remain unaected.

IMPORTANT NOTE:

This process will overwrite any user saved patches and settings.

English

Front Panel

1. Input

Plug your guitar in here.

Always use a good quality screened guitar lead.

2. Voice

The Voice control changes the preamp voicing, ranging from ultra clean to extremely

overdriven.

 Clean Warm – Classic clean, dynamic

 Clean Bright – ‘Boutique’, will break up when pushed hard

 Crunch – Classic medium gain overdrive

 Super Crunch – More gain and punch than Crunch

 OD 1 – Hot-rodded Master Volume overdrive

 OD 2 – Mid boosted overdrive

This setting is saved when you store a patch.

3. Gain

The Gain control adjusts the amount of overdrive or distortion. Low settings (counter

clockwise) will deliver a clean sound on the edge of break-up. As the Gain control is

turned clockwise the sound will become more overdriven, moving through beautiful

crunch tones until, at its maximum position, a full distorted tone is achieved. This

setting is saved when you store a patch.

4. Volume

This controls the preamp volume. High levels of volume will introduce the effect of

valve power amp distortion and compression. This is a global setting and not saved

when storing a patch.

5. ISF

The patented ISF control allows you to choose the

exact tonal signature you prefer. Fully counter clockwise

has a more American characteristic with a tight bottom-

end and more aggressive middle, and fully clockwise

has a British characteristic which is more ‘woody’ and

less aggressive. This leads to a very familiar, musical

response. This setting is saved when you store a patch.

6. MOD (Modulation)

Press this switch to turn the stereo modulation effect on, off, or focus the effect for

editing. This setting is saved when you store a patch.

7. DLY (Delay)

Press this switch to turn the stereo delay effect on, off, or focus the effect for editing.

This setting is saved when you store a patch.

AUK

1 2 3 4 5 6 7 8 9 10 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Blackstar ID:Core Stereo 10 Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Blackstar ID:Core Stereo 10